Fenix PD35 960

Write a Review
Calculated at Checkout
- - - - - - -
FL-1 Lumens 960 460 180 50 14 960 Strobe
Runtime 1 hr 10 min 3 hr 15 min 10 hr 38 hr 150 h -
Peak Beam Intensity - -
Throw Distance - -

Beam Profile:
Hot Spot: -°
Spill (Flood): -°
Hotspot Diameter at 100m: - m

1* 18650
2* CR123A

Operating Voltage: 0.0V - 0.0V
Operating Temperature: -25°C to +40°C

On/Off Control: Tail Cap Button
Mode Switch Control: Tail Cap Button
- Max Output: Head Tight
- Main Outputs: Head 1/8 Loosened
-- Cycle Output: Half Press and Release Button

Length: 10.2 cm
Body Diameter: 2.54 cm
Head Diameter: 2.54 cm
Weight (w/o Batteries): 60 g

LED: Cree XM-L2 U2
Tint: Cool White (----K)

Body Material: Aircraft Grade Aluminium
Body Finish: Premium Type III Hard Anodization 400HV

Lens: Impact Resistance Glass w/ Sapphire and Anti-Reflection Coating

Dust/Water Resistance Rating: IP x8
Impact Resistance: 1 m
Submersible Depth: 2 m

Package Contents:
PD35 Flashlight
1 Spare O-Rings

Now, Fenix PD35, the best-selling model is upgraded to 960 lumens. Weighting only 87 grams and less than 14 centimeters long, PD35 2014 delivers a stunning 960-lumen maximum output from one 18650 battery.


·Cree XM-L 2 (U2) LED with a lifespan of 50,000 hours
·Uses one 18650 rechargeable Li-ion battery or two 3V CR123A Lithium batteries
·139mm (Length) x 25.4mm (Diameter)
·87-gram weight (excluding the battery)
·Digitally regulated output - maintains constant brightness
·Low-voltage warning function to remind you to replace the batteryReverse polarity protection guards against improper battery installation
·Over-heat protection to avoid high-temperature of the surface
·Anti-roll, slip-resistant body design
·Tactical tail switch with momentary-on function
·Side switch on the headMade of durable aircraft-grade aluminum
·Premium Type III hard-anodized anti-abrasive finish
·Toughened ultra-clear glass lens with anti-reflective coating


1 Review Hide Reviews Show Reviews

  • 4
    Armytek c2 v 1.5

    Posted by Jean Claude Lavallee on 20th Aug 2016

    I own this li like this little light very much its not too big easy to carry around I used it often at work in prosthetic field at 200 lumen it's enough to through laminate or look and assemble battery and wire inside outer arm shell I used it to hike around I found also that 200 and 400 lumen is more than enough light for most time ,the warm color might be too yellowish I hardly ever use the full 1000 lumen I don't think it warrant a long life the light is too small to dissipate all that heat I believe it is amazing all the light from such a small device I don't have 18650 cell yet so the run time is a bit short in all I think it's a great light