Loading Please Wait  Loading... Please wait...
  • Image 1
  • Image 2

EagleTac D25AAA


Brand: Eagletac

Calculated at checkout

Product Description

Note: The Nichia is now with a Gray decorative trim (used to be Blue).


Twist head control for on/off control and output mode cycling. Lanyard hole in the tail for hanging the flashlight from a lanyard or other cords. Pocket clip installed for secure pocket transportation. Rare-earth magnet in the tail allows for attaching the flashlight to magneting surfaces during use or convenient storage such as on the side of a fridge. Coloured ring on the body is decorative but can be useful for situations where two flashlights are in use, one with a regular Alkaline or Ni-MH AAA battery and the other with a Li-Ion 10440 battery.

What's Included

  • D25AAA Flashlight
  • Spare O-Rings (2)
  • User Manual
  • Stainless Steel Clip (attached)
  • Rare-Earth Magnet (integrated into the flashlight tail, grey coating to increase magnet durability)


Battery reverse polarity protection.

Ultra-low internal resistance phosphor bronze springs w/ silver coating.


Cool White: Cree XP-G2 S2

Output and Runtime

XP-G2 S2

  • LED Lumens: 145/60/12
  • ANSI Lumens: 85/40/8
  • Runtime: 0.7/1.3/6 hrs

Beam Profile

XP-G2 S2

  • Center Lux: 500 lux
  • Center Spot Angle: 19.3°
  • Spill (Flood) Angle: 55°
  • Beam Distance: 50 yards / 45 meters

Battery Type

1xAAA or 1x10440* (Not Included)

Compatable Battery Size:

  • Diameter: 10-10.5mm
  • Length: 44-45mm

Batteries must have protruding button top.

*Limit use of flashlight at highest output when using Li-Ion to prevent overheating.
** Not compatable with Protected 10440 (10460) batteries.

Operating Voltage

0.8V - 4.2V


  • 1.2V Ni-MH
  • 1.5V Alkaline
  • 1.5V-1.7V Lithium
  • 3.7V Li-Ion


Waterwhite glass lens w/ harden treatment.
Anti-reflective (AR) coating on both sides (96% transparency).

LED Circuit


  • High switching frequency (1MHz) controller for more compact circuitry design.
  • Low internal resistance design offers up to 90% efficiency*
  • Non-dimming constant current regulation for all output levels.
  • Zero standby current.
  • Supports output dimming with Li-Ion battery.
  • Allows LED direct drive with Li-Ion battery at high mode.
*Highest efficiency achieved when input voltage is very close to LED forward voltage.

Body Material

  • HAIII hard anodization aerospace aluminum


  • Smooth aluminum reflector


  • IP-x8 standard


Head Diameter: 0.55 inches (14 mm)

Body Diameter: 0.5 inches (13 mm)

Length: 2.7 inches (70 mm)

Weight w/o Batteries: 0.4 ounces (13 grams)


On: Tighten the head of the flashlight.

Off: Loosen the head of the flashlight until the light turns off.

Mode Change: Rapidly turn the flashlight off and on again to advance one output mode. Returns to the first output when advancing past the final auxilery output.

Mode Cycle: Low > Medium > High > Low > Medium > High > Strobe I > Strobe II > Flash > S.O.S. Fast > S.O.S. > Beacon > Flash Low






  • Ten years performance guaranteed warranty

Product Reviews

Write Review

  1. Practical Review Rating

    Posted by Michael Zelick 2 tours in Afghanistan used these little suckers there light and project good light. on 25th Feb 2016

    I have 2 I rip off the march calendar page and at both ends I put the flashlights.

  2. great edc flashlight Review Rating

    Posted by Unknown on 20th Feb 2016

    This is a great little flashlight. Three modes of operation is nice, although the head is a little bit small, it takes a little getting used to to change modes with one hand (not as easy as the thrunite ti3). The spec says 85 lumens, I am assuming this is with a regular AAA battery. With a 10440 it has to be closer to 175-200 lumens. After a minute or so it starts to get pretty warm on high. I have been carrying this light everyday for a few weeks now and I love it. I plan on getting another one for a back up.